Recent content by b0re

Hello, I was trying to contact victron but all the posts relating to the ET112 are closed. It's a simple setup just wanted acknowledgment of the wiring I have gone for. Victron diagram This is what I have Clearly missing the input and outputs. And also the RJ45 on pins 4,5 and 6. I...

Its 12v. Yes, I have been using it for 6months had no issues.

Did a test today I added an additional cable to the 12v still had the same problem. This time i turn the 12v off, then turned the inverter on then turn the 12v on im still getting the same problem. Could this be related to the Orion 24v-12v DC-DC Converters Non-isolated. I can buy an isolated...

Thanks

Hello, I created a 7s pack each pack is 279551 milliampere-hours so 279.551Ah per pack Do you times 279.551Ah by the packs to give you the total Ah or is it 279.551Ah? Thanks

I will swap the wire and if that does not work I will then try the capacitor option Thanks

Hello, I have a Diesel heater powered by an Orion 24v-12v DC-DC Converters Non-isolated. When turned on everything works fine as soon as I turn on the invertor the Diesel heater shows error code 7, this means low voltage to the controller. I checked the controller's voltage when on and the...

Hello, I want to turn off the 24v via remote using Zigbee, I am currently using Sonoff. The BP-65 Victron comes with a remote loop does anyone know the voltage between the jumper on/off I want to add in a Zigbee switch between the jumper that I can tie into the rest of my Zigbee devices and...

Can use this on a non-Victron inverter? https://www.victronenergy.com/panel-systems-remote-monitoring/phoenix-inverter-control-ve.direct Looking at the wiring it looks like you can?

Ok will do

Hello, I have the Victron GX and I want to turn on and off a 12v supply its 30amp Can you recommend a relay to work with the GX? Thanks

Ok I can connect the shunt and the mppt but can see any were in the setting to connect them to the cerbo gx

Great will take a look

Hello, I have a smart shunt smart solar mppt 100/30 Victron control gx cerbo gx Can I link these via Bluetooth and not use cables? Thanks

This is what I have gone for the bars over the top is rated at 45amps per line. I have not cleaned up the solders or shrink-wrapped it yet. The out put cable is 400ams just because thats what i had.