Later on I will play with this setting, for now, since the Esmart3 is 0.8 below the battery
I will lower the bulk float equaliztion values by 0.8
So to have a sync charging with reality
Then I will review load and PV voltage when PV are ready :)
I do program... so I need to dive into Python and...
second field in the right column, you put the V value or the "1658" number that match my Battery voltage?
My Esmart3 CC is 0.8 away from the battery voltage, I was thinking increase 0.8 to each bulk float etc. value to leave like this :)
Opinions please
Hi All,
while testing batteries on my Liitokala 500.... two Sanyo's gave me that "Pop" sound and stop registering, I tooked out and was discharging .
Is common that this portectiong arise or could be the charger?
Thanks in advance!
CG.
Hi All,
I have been reading that each parallel should have cells within 50 to 100mAh
But in Repackr.com when I usi it, give me in each parallel block on top 2600 and the bottom of the "p" 1800mah ones....
Can you please clarify what im missing :(
Thanks!
For me the best practica is Solder the strands.... never failed for me at least :)
I indeed have a 14S system you nailed again with this advise :)
Thanks !
Im working to finish my wiring to 240, making some space for a new 240 breaker....
Now, I can directly plug battery and solar to the GTIL input poles ?
One more question, GTIL will device the load from solar / bat equally to L1 and L2, or per requirements?, at the on both cases will be zero out right ?
CG
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.