Yes i measured right at the cells and had the same reading so its not a function of the wires or BMS. I didn't use fuse wires but instead the roll of 4 cell wide jumper grid so full on battery destruction is next it seems.
Re BMS, I couldn't get the Bluetooth dongle to communicate at all. Then I...
I built 4 battery packs of 18650 cells I harvested from E-bike batteries. Every cell was tested on a LiitoKala lii-500 and charged up to full energy then left to age for at least a month then disposed of if there was any self discharge. Each battery is 7s18p.
I powered up the first two packs...
What load were you switching? That is the exact behavior of a AC solid state relay when it tried to switch DC. They rely on the zero crossing point for the triac to disconnect and there isn't a zero crossing in DC. The image you show is also an AC solid state relay.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.