Sean
Member
- Joined
- Oct 8, 2016
- Messages
- 936
I'm finally getting round to installing these, connectivity documentation for these is non existent, but following that of the other mons I suspect it's as it should be.
So I've followed the setup "wizard" - telling it there's 6 mons etc, but it's not seeing them all. Occasionally, I've seen a couple of cells showing in the chart, but the network test fails due to timeout and/or with "acknowledgement different to setup" which obviously implies it's expecting to see something else via the setup wizard ?
Tx & Rx have connectivity, 6 leaf cells, all around 3.9v
I can only see 1 other system on here built using Leafmons, and that seems to have fired up straight away.
Can anyone spot what I'm doing wrong in the images below ? - I'm no stranger to systems like this, but my patience is waining with this one.
I have no idea why those images have been rotated, here's one of the other cells (probably also inverted)
The BMS is being installed on six single leaf modules simply to test.
So I've followed the setup "wizard" - telling it there's 6 mons etc, but it's not seeing them all. Occasionally, I've seen a couple of cells showing in the chart, but the network test fails due to timeout and/or with "acknowledgement different to setup" which obviously implies it's expecting to see something else via the setup wizard ?
Tx & Rx have connectivity, 6 leaf cells, all around 3.9v
I can only see 1 other system on here built using Leafmons, and that seems to have fired up straight away.
Can anyone spot what I'm doing wrong in the images below ? - I'm no stranger to systems like this, but my patience is waining with this one.
I have no idea why those images have been rotated, here's one of the other cells (probably also inverted)
The BMS is being installed on six single leaf modules simply to test.