SimpBMS setup - alarm settings

Announcement - Help us fight the BOTS! Please report all spam including stuff in your inbox!

mfuchs

New member
Joined
Aug 2, 2021
Messages
3
Hello,
i'm currently setting up a storage using SimpBMS with Tesla batteries. In general, everything works fine. But I have a problem with the alarm settings...
Here an example:
Upper voltage limit: 4100mV
Under voltage limit: 3500mV

When the minimum value of a cell goes under 3500mV it turns off, but when the maximum value goes over 4100mV the BMS does not turn off. When I do a restart it shows an error (what it should), but during charging it keeps running...
Does anyone know what is wrong here?

Thanks for every advice!
 

italianuser

Member
Joined
Feb 25, 2020
Messages
376
Hi there and welcome to you!

This is the introduction section so I can welcome you but if I answer @Korishan will discharge my powerwall from remote 😅

So... please do write a new post in BMS section to get answers!
 

Korishan

Moderator
Joined
Jan 7, 2017
Messages
6,573
if I answer @Korishan will discharge my powerwall from remote
:LOL: Greetings are always welcome. And short answers are fine in the introduction. It's just that long/detailed answers/comments should be put into a new thread ;)

@mfuchs Thanks for joining the club. I'm sure someone who is familiar with your plight will help you out. Lots of knowledgeable folk here on various platforms and backgrounds. That might be @italianuser who has the answer, for instance ;)
 
Top