I am having an odd issue and I am trying to figure it out. When the WM5 goes into bypass some of the cells will read very high for a second or two. Jumping from 4.10 to 4.2 or 4.3 I don't understand how this could happen. If anything I would expect the voltage to drop as it is bypassing .5 amps. a 189ah cell is obviously not going up and down 2/10's of a volt in a second unless it was on fire, I would ignore it as a faulty reading but it is causing my inverter to go into protect mode as the Batrium is sending it the alarm.
Any thoughts or has anyone seen this?
Thanks,
Will
Any thoughts or has anyone seen this?
Thanks,
Will