Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
3D & 14500 Cell’s
I’m new to this building of packs.
And have zero experience ( other than looking ) with 3D printers.
I would like to print ( I can not find them to buy ) some holders for the 14500 cells. The standard 4-5 18650 type of holders.
Being new to even looking at 3D Any recommendations concerning the printers.

T. I.A
three or four layers of tape wrapped around the top and bottom should let you use the 4x5 cell holders
lster floyd
Not into tape at this time. Still checking into printing
Update I tried using 18650 spacer/ holders . They will work turned upside down. Just take up a lot of space .
plenty of holders for those.
if you want to print some look for the .stl for aa holder.

Forum Jump:

Users browsing this thread: 1 Guest(s)