Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
TP5000 module review (and technical details)
#30
I often put 2 or 3 cells in parallel on the TP4056 boards. That way, each cell only sees 500 or 333 mA. I try to group them by similar Voltage. Keeps one from discharging into another, and hopefully, they'll be in about the same condition. Especially if they came out of the same battery. I imagine you could do the same with the TP5100.

Those tiny resistors are a challenge to get off. I've managed with a fine tip iron and tweesers. Not every attempt has been a success though. I've had to through out a few failures.

I hope things go well, whatever you do. Smile
fannel likes this post
-Mike G
Reply


Messages In This Thread
RE: TP5000 module review (and technical details) - by rebelrider.mike - 01-21-2020, 01:13 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)