Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Tracking down critical faults
#4
Almost sounds to me like a bad connection, or a loose solder connection somewhere. Either your work, or on the shunt or other device. Would be interesting to know what is causing it.

I'm sure you've already done it, but try going through all connections and verify their connections. This includes the connections on the longmons themselves. Make sure they are securely fastened. You could even try wiggling the connectors slightly and see if the WM will trigger an event. Even if the pins and connector are tight, the pins to the board could be loose or cracked solder (just a thought).
Proceed with caution. Knowledge is Power! Literally! Cool 
Knowledge is Power; Absolute Knowledge is Absolutely Shocking!
Certified 18650 Cell Reclamation Technician

Please come join in general chit-chat and randomness at Discord Chat (channels: general, 3d-printing, linux&coding, 18650, humor, ...)
(this chat is not directly affiliated with SecondLifeStorage; VALID email req'd)
Reply


Messages In This Thread
Tracking down critical faults - by HughF - 07-08-2019, 11:50 AM
RE: Tracking down critical faults - by Korishan - 07-08-2019, 12:02 PM
RE: Tracking down critical faults - by HughF - 07-08-2019, 12:06 PM
RE: Tracking down critical faults - by Korishan - 07-08-2019, 01:09 PM
RE: Tracking down critical faults - by HughF - 07-08-2019, 01:17 PM
RE: Tracking down critical faults - by Sean - 07-08-2019, 01:22 PM
RE: Tracking down critical faults - by HughF - 07-08-2019, 01:30 PM
RE: Tracking down critical faults - by HughF - 08-30-2019, 02:29 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)