Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
fuse Wire
#11
(02-02-2020, 08:02 AM)rolfbartels Wrote: Thanks everyone, I managed to get 35 awg tined copper wire for about $9, I tried fusing it at 10apms but it didnt blow, but thern I am not 100% sure it was 10amp,
I was using a ISDT charger and set to 10A to charge a 12P pack, it got very hot just dint blow at about 1.5cm
35awg should melt at 4-5a.    I can attest that 30awg (is what I use) definately metls thru on my packs - as it sometimes unspools to the bottom side of the pack when I'm soldering on the top side....  and burned my fingers more than once Smile

Here's a chart from lower on this link  https://en.wikipedia.org/wiki/American_wire_gauge     It lists fusing current (right hand columns) vs wire size and I believe these numbers are reasonable Smile
Reply


Messages In This Thread
fuse Wire - by rolfbartels - 01-30-2020, 09:34 AM
RE: fuse Wire - by daromer - 01-30-2020, 10:41 AM
RE: fuse Wire - by mike - 01-30-2020, 12:43 PM
RE: fuse Wire - by Korishan - 01-30-2020, 01:28 PM
RE: fuse Wire - by OffGridInTheCity - 01-30-2020, 03:43 PM
RE: fuse Wire - by Crimp Daddy - 01-30-2020, 05:18 PM
RE: fuse Wire - by mike - 01-30-2020, 05:28 PM
RE: fuse Wire - by jonyjoe505 - 02-01-2020, 08:57 AM
RE: fuse Wire - by ajw22 - 02-01-2020, 09:40 AM
RE: fuse Wire - by rolfbartels - 02-02-2020, 08:02 AM
RE: fuse Wire - by OffGridInTheCity - 02-02-2020, 05:18 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)