Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Mistake busbars ?
#11
What you might be able to try is to take the Neg of both meters and connect them at the same point on one end. Then take the Pos of one and connect it to the same end and the Pos of the other and connect at the other end. This "may" give you a voltage difference. It's just that the two meters must have a common starting point. Connecting them completely at either end won't yield any differences as they can't show you the true load across the pack.

But, then again, if your buss bars large enough, they won't show any differences anyways as the voltage drop is too low, or non-existent. You could test your voltage drop across the buss bar by using it as a shunt type of connection. Put a load across the buss bar and see what the voltage drop is at either end that way. This would allow you to use your multimeter in .0001 mode instead of the .001 or .01. We don't care about full voltages, we care about the milli-volts or micro-volts.
Proceed with caution. Knowledge is Power! Literally! Cool 
Knowledge is Power; Absolute Knowledge is Absolutely Shocking!
Certified 18650 Cell Reclamation Technician

Please come join in general chit-chat and randomness at Discord Chat (channels: general, 3d-printing, linux&coding, 18650, humor, ...)
(this chat is not directly affiliated with SecondLifeStorage; VALID email req'd)
Reply


Messages In This Thread
Mistake busbars ? - by wim - 09-19-2017, 06:06 PM
RE: Mistake busbars ? - by Korishan - 09-19-2017, 07:37 PM
RE: Mistake busbars ? - by dougal - 09-19-2017, 09:09 PM
RE: Mistake busbars ? - by jdeadman - 09-20-2017, 12:29 AM
RE: Mistake busbars ? - by Hanssing - 09-20-2017, 04:15 AM
RE: Mistake busbars ? - by daromer - 09-20-2017, 05:51 AM
RE: Mistake busbars ? - by wim - 09-20-2017, 03:21 PM
RE: Mistake busbars ? - by dougal - 09-20-2017, 04:14 PM
RE: Mistake busbars ? - by Korishan - 09-20-2017, 04:13 PM
RE: Mistake busbars ? - by wim - 09-20-2017, 05:58 PM
RE: Mistake busbars ? - by Korishan - 09-20-2017, 07:29 PM
RE: Mistake busbars ? - by wim - 09-20-2017, 08:29 PM
RE: Mistake busbars ? - by Korishan - 09-20-2017, 08:43 PM
RE: Mistake busbars ? - by wim - 09-21-2017, 05:08 AM
RE: Mistake busbars ? - by Korishan - 09-21-2017, 01:30 PM
RE: Mistake busbars ? - by SimonW - 09-21-2017, 02:11 PM
RE: Mistake busbars ? - by Korishan - 09-21-2017, 02:34 PM
RE: Mistake busbars ? - by wim - 09-21-2017, 03:21 PM
RE: Mistake busbars ? - by Korishan - 09-21-2017, 03:34 PM
RE: Mistake busbars ? - by SimonW - 09-21-2017, 03:36 PM
RE: Mistake busbars ? - by Ronny - 12-01-2019, 11:15 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)