Hi, new this forum. Tried looking for an answer but couldn't find adequate answers. Hopefully someone here can provide some insight.
Planning out a portable4s60p setup. Probably to be used for emergency setups, RV or off roading.
Likely to have18650s soldered to a copper bus bar or a rod.
The worry here is keeping thepack from bouncing around in the case, and possibly doing damage to itself.
My current ideas are:
Planning out a portable4s60p setup. Probably to be used for emergency setups, RV or off roading.
Likely to have18650s soldered to a copper bus bar or a rod.
The worry here is keeping thepack from bouncing around in the case, and possibly doing damage to itself.
My current ideas are:
- Wrap the entire pack, and add foam padding on the outside. (Heat generation worries me)
- Add a rubber or insulating pad against the pack and case.
- Just add some foam because I'm overthinking things