Batrium Bypass Test Failed

Wattsup

Wattsup

Member
Joined
Feb 19, 2017
Messages
513
I have setup my 16 x 100 ah LiFe cells in 48v and just installed the batrium.

I just ran the bypass tester and notice 1 node failed. Does this mean the cellmon is faulty?

See pic below


image_dhptxn.jpg
 
image_mjqyoc.jpg


Go into options and change start temperature to lower than the one that failed. It seems you have one sensor that is off and then just rerun.
 
daromer said:
image_mjqyoc.jpg


Go into options and change start temperature to lower than the one that failed. It seems you have one sensor that is off and then just rerun.
Click to expand...

Yep sorted. You were right.
Thanks for the quick response, appreciate it!

There is so much to learn with this system.

One thing I personally would like is a paper hard copy manual.
I know everything is going paperless but I prefer it with this sort of thing.
 
You can always print out their Support page. Most of it is there :) Rest is in Jarons head ;)
 
daromer said:
You can always print out their Support page. Most of it is there :) Rest is in Jarons head ;)
Click to expand...

Yes but there would be no index which would be a PITA.

It's fine. Just a thought
 
You must log in or register to reply here.
Back
Top