Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Batrium BMS Update & Questions
#1
Bit of an update on my BMS install  Smile


                                                Choose LiFe  Wink

                      May all your batteries be fully charged and perfectly balanced  Cool
Reply
#2
I have a couple more questions  Smile

1. Should I choose LiFePO4 - Long life, or Typical for the CALB cells, or is it not important?

2. Also is there a way to set battery bank voltage for the system?

3. In Setup wizard, it has nominal capacity as 120.000, should I be changing this?

Thanks
                                                Choose LiFe  Wink

                      May all your batteries be fully charged and perfectly balanced  Cool
Reply
#3
1. Long life. Same as with Laptop cells where you dont go to 4.2V you only go to max 3.5 on LiFe.
2. If you are running the Batrium from the bank main voltage you get a sense of total voltage there. But its more accurate with the shunt when you get that one installed. You can though group strings: https://www.batrium.com/pages/understand...n-settings Check Diff nominal.
3. Im not sure if thats "used" without the shunt.

Lets have Jaron fill in Smile
Wattsup likes this post
NOTE! My links supplied in this message may be affiliated with Ebay and by clicking on them you agree on the terms.
YouTube / Forum system setup / My webpage  Diy Tech & Repairs

Current: 10kW Mpp Hybrid | 4kW PIP4048 | 2x PCM60x | 100kWh LiFePo4 | 20kWh 14s 18650 |  66*260W Poly | ABB S3 and S5 Trip breakers
Upcoming: 14S 18650~30kWh
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)