winny said:How do I proceed from here? Anyone seen it befor? Is it glued in place?
Overmind said:The ones I've opened have the 2 plastic parts being held together by special screws.
100kwh-hunter said:Why you don't get a wooden dowel that is a tad smaller then the cell?
Small taps on the neg side, take a 2 pound hammer for the mass, it works better than a 1 ounce hammer with a lot of heavy taps.
just my two cents, hope this will help a bit
Good grief! I'll keep that in mind but I do value my time...ajw22 said:I took apart several similar packs using a box cutter knife. Just kept slicing at the same line until I was through, then split the whole thing apart with brute force.
On some, they also like to epoxy the cells into place. Just slice the sleeve and push out the cell, then resleeve.