Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Nickel sheets
#1
Hi,

I am developing my connection concept and instead of using copper bus bars looking to create nickel sheets with sprung connection/fuse punched into them. I need some sheeting to test my concept and so...

My question is where is best to by sheets of Nickel? aliexpress?
i need them 350 by 135 by .2 -.3 thickness 

thoughts?
Reply
#2
eBay is always the best for small amounts ....Pure nickel may be a bit floppy , I have worked with Stainless Steel 0.1 and 0.15  , very strong and ridged in thin sheets , can be cut with scissors , spot welds well ... it does have fairly high resistance but this is not a problem when in sheet form . electricity moves in all directions

Stainless 0.1 
 [Image: s-l225.jpg]
Below Pure nickel too bendy, floppy  ... nickel plate is not so bendy 

[Image: s-l225.jpg]
Scottietheyoung likes this post
Reply


Who read this thread?
23 User(s) read this thread:
hbpowerwall (07-23-2019, 08:35 PM), Beholder (06-21-2019, 09:51 PM), Wolf (06-20-2019, 11:16 AM), Bastler_Ro (06-20-2019, 06:02 PM), Scottietheyoung (09-27-2019, 04:31 AM), Generic (06-20-2019, 03:03 PM), ajw22 (06-20-2019, 08:25 AM), Overmind (06-20-2019, 09:41 AM), Androfire (07-10-2019, 06:00 AM), stok (07-25-2019, 06:41 AM), emuland-metroman (06-26-2019, 07:44 AM), thunderheart (06-22-2019, 07:07 PM), Headrc (06-21-2019, 02:19 AM), Korishan (06-20-2019, 11:38 AM), ozz93666 (06-20-2019, 06:58 AM), wim (06-20-2019, 09:48 AM), watts-on (06-21-2019, 08:45 AM), BlueSwordM (06-26-2019, 03:29 AM), Geek (06-21-2019, 12:38 AM), spinningmagnets (06-21-2019, 07:12 PM), HughF (09-01-2019, 07:32 AM), Chablis_m (07-10-2019, 02:21 AM), jiggyjonboat (08-07-2019, 02:02 AM)

Forum Jump:


Users browsing this thread: 1 Guest(s)