Thread Rating:
  • 2 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Limiter inverter with RS485 load setting
#10
Will try and get the full protocol out from the manufacturer (some hope...) because the units appear to be programmable for constant voltage, constant current and constant power (default)...

Suspect the 24/56 is a standard hearder for the device.
00 - single unit active (increases by 1 per unit - acts as a divisor for the power measurement)
21 - no idea

Or could be just simple 2 byte word packet.
Unit ID
Unknown/settings (21 = Constant power mode as a guess ??)
Target setting in Watts/Volts/mA
Checksum

They are interesting units and possibly one of the most accessible (output setting options) cheap inverter uinits on the market at the moment, shame they lack official grid certification in virtually every country in the world....

If you can't quantify how much they cost, it's a deal, I'll buy 5 of them for 3 lumps of rocking horse ......
Reply


Messages In This Thread
RE: Limiter inverter with RS485 load setting - by completelycharged - 08-10-2019, 01:27 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)