Thread Rating:
  • 2 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Limiter inverter with RS485 load setting
#17
Manufacturer replied "Currently we do not have the RS485 protocol." So we are on our own.

I am testing a "man in the middle" setup with the inverter, in that I read what the sensor outputs, modify it, and instantly send the new value to the inverter. I noticed that the inverter is less efficient when it maxes out, so I want to cap the maximum power requested depending on the available power. The inverter is also less efficient when run at low power (<30W), and this approach should also allow to zero the power output when the demand is very low.

What do you think?
Reply


Messages In This Thread
RE: Limiter inverter with RS485 load setting - by CarlosGS - 11-19-2019, 03:48 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)