Thread Rating:
  • 2 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Limiter inverter with RS485 load setting
#55
There is something a little odd with the units, however in my case (same issue of inverter stopping responding to RS485 data) the issue was the transmitter end and at the time seemed to occur IF the low voltage cut-off was reached. With the inverter running between the normal voltage range the iverter worked fine and has done for over a month. This was part of the reason I ended up adding in a voltage detection and control override on the power output to prevent the unit from reaching battery cut-off. I ended up setting the cut-off voltage at near 0kWh (effectively emergency cut-off) and just control the ouput on/off purely with the separate code.
If you can't quantify how much they cost, it's a deal, I'll buy 5 of them for 3 lumps of rocking horse ......
Reply


Messages In This Thread
RE: Limiter inverter with RS485 load setting - by completelycharged - 07-10-2020, 02:00 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)