Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
14s20p PowerWall
#1
Hi guys, the building begins !

I used rePackr to make my 14 sets of 20 batteries :


Then, I made the barbus :


Ready to sold :


Soldering the fuses :


I have a question about the fuses : Is it needed to sold one fuse at each end of each cell ??
Reply
#2
No, just on one side ... usaly we put them the positive side only. 
but yeah, trop tard,  on the negative side works also i guess  Smile
Korishan likes this post
___________________________________
18x 300Wp solar off grid and 10x 180Wp solar tracker grid-tie
10KW 3phase hybrid inverter. 40Kwh 18650 storage (for now)
My setup: https://secondlifestorage.com/t-Instant-powerwall
Reply
#3
Ho ok, each side seemed a little extreme lol

What about the other side, what should I use to link the cell to the bus bar ?
Reply
#4
Some copper wire, like 0.75mm2 or so, just to keep the cells from turnig in the holders.
Lots of examples everywhere here.
Korishan likes this post
___________________________________
18x 300Wp solar off grid and 10x 180Wp solar tracker grid-tie
10KW 3phase hybrid inverter. 40Kwh 18650 storage (for now)
My setup: https://secondlifestorage.com/t-Instant-powerwall
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)