Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Building 7s15p 18650s- how to solder them?
#1
I'm building a 7s15p pack, using the common 5x4 18650 frames. 
Because the 15p will be 3 rows of 5, how should I solder them? tabs between the center row cells w/ fuse wires to the outside cells? 
Has anyone done this that could share pics?
Reply
#2
go 16p and put a bar between each row. This will make fusing a lot easier. So it would be on the 4 side, not the 5 side of the holders.

That's my suggestion.
philsocal likes this post
Proceed with caution. Knowledge is Power! Literally! Cool 
Knowledge is Power; Absolute Knowledge is Absolutely Shocking!
Certified 18650 Cell Reclamation Technician

Please come join in general chit-chat and randomness at Discord Chat (channels: general, 3d-printing, linux&coding, 18650, humor, ...)
(this chat is not directly affiliated with SecondLifeStorage; VALID email req'd)
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)