richie241
Member
- Joined
- Nov 6, 2018
- Messages
- 34
Hi all,
first of all many thanks for this forum and the helpful contributions
Finally my project has started! Wohooo
For about a year I've been following the posts and had recycled
cells, read posts, recycled cells...
A half year and 2000+ Cells tested later i sold all used cells... puh!
I thought about it for a long time - I want to build a powerwall as long as possible - so I decided to build new cells.
My choice is the LG 18650 M36 3600mAh.
'Modular' because i start with a 14S60P Setup.
After everything works well i put 14x 60/120 more packs to the Setup.
Finaly im planing with round about 21-25kWh.
Hybrid Inverter: SolaX Hybrid II 3700 G2 feed from 14x 300W Panels
BMS: Batrium
But as always in life: First the work, then the pleasure
The Powerwall is located in my Garage, Finished with Fermacell plates (non-combustible)
I added 2 140mm Fans + a Controller in the Housing, more Fans later
The housing is also equipped with Fermacell plates (two-layer). Safty first ;-)
All Packholders are ready and were produced by 3D printer.
Thats it for now - new Updates next week
first of all many thanks for this forum and the helpful contributions
Finally my project has started! Wohooo
For about a year I've been following the posts and had recycled
cells, read posts, recycled cells...
A half year and 2000+ Cells tested later i sold all used cells... puh!
I thought about it for a long time - I want to build a powerwall as long as possible - so I decided to build new cells.
My choice is the LG 18650 M36 3600mAh.
'Modular' because i start with a 14S60P Setup.
After everything works well i put 14x 60/120 more packs to the Setup.
Finaly im planing with round about 21-25kWh.
Hybrid Inverter: SolaX Hybrid II 3700 G2 feed from 14x 300W Panels
BMS: Batrium
But as always in life: First the work, then the pleasure
The Powerwall is located in my Garage, Finished with Fermacell plates (non-combustible)
I added 2 140mm Fans + a Controller in the Housing, more Fans later
The housing is also equipped with Fermacell plates (two-layer). Safty first ;-)
All Packholders are ready and were produced by 3D printer.
Thats it for now - new Updates next week