Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Question about using PowerBank DIY Case to charge 18650
#1
Hi everyone.

I have been using the IMAX B6 MINI to make the initial charge.

Then i test them with lii-500.

I am currently needing another way to charge all the way after the initial test.

I have been looking into the cheap DIY Power Bank Box Case for that.

Does anyone here use them.

Thanks.
Reply
#2
You should be using the NOR TEST mode on your charger. The NOR TEST mode will charge, discharge (test), and charge back up automatically. The capacity report is the capacity measured during the discharge part of the test cycle.
Reply
#3
(10-10-2019, 05:27 PM)mike Wrote: You should be using the NOR TEST mode on your charger. The NOR TEST mode will charge, discharge (test), and charge back up automatically. The capacity report is the capacity measured during the discharge part of the test cycle.

And that is what i do.

But i have new charged batteries before the lii-500 finish charging back after the test.

So i am looking for a way to do that without spending to much money. Blush
mike likes this post
Reply


Who read this thread?
19 User(s) read this thread:
Sean (10-10-2019, 06:14 PM), BatteryMooch (10-11-2019, 01:55 AM), iNeedMoarProtection! (10-10-2019, 11:36 PM), LPG (10-10-2019, 08:24 PM), 100kwh-hunter (10-12-2019, 04:52 PM), winny (10-12-2019, 12:21 PM), OffGridInTheCity (10-10-2019, 08:24 PM), ajw22 (10-11-2019, 02:48 PM), chuckp (10-10-2019, 08:49 PM), w0067814 (10-11-2019, 01:22 PM), Bubba (10-10-2019, 11:13 PM), Ibiza (10-10-2019, 08:07 PM), Oz18650 (10-10-2019, 09:10 PM), Geek (10-11-2019, 12:21 AM), Mazlem (10-11-2019, 02:44 PM), jdeadman (10-10-2019, 05:57 PM), Korishan (10-11-2019, 12:12 AM), mike (10-11-2019, 02:47 AM), juliomgm (10-10-2019, 05:57 PM)

Forum Jump:


Users browsing this thread: 1 Guest(s)