Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
LiitoKala Li-500 Fan Cooler Shroud - 3D Printing
Here is a 3D-printable fan cooler shroud for the LiitoKala Li-500 capacity tester charger. The original design was made by a member of the Facebook group.

Download Link:

hbpowerwall likes this post
Pretty useful. This is the exact method that I use to cool Opuses and sometimes there's trouble putting the fan in place because it can accidentally touch something and cause bad things to happen. Would be nice to have a similar design for the Opus too.
hbpowerwall and mike like this post
The fan I added to my Lii-500 is on the back and tagged into the power lead for the Lii-500 since it's 12 volts anyways.  I'm not sure how you check for heaters with the fan on the front like this?

Forum Jump:

Users browsing this thread: 2 Guest(s)