Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
LiitoKala Li-500 Fan Cooler Shroud - 3D Printing
#1
Here is a 3D-printable fan cooler shroud for the LiitoKala Li-500 capacity tester charger. The original design was made by a member of the Facebook group.

Download Link:
https://www.thingiverse.com/thing:3989224

hbpowerwall likes this post
Reply
#2
Pretty useful. This is the exact method that I use to cool Opuses and sometimes there's trouble putting the fan in place because it can accidentally touch something and cause bad things to happen. Would be nice to have a similar design for the Opus too.
hbpowerwall and mike like this post
Reply
#3
The fan I added to my Lii-500 is on the back and tagged into the power lead for the Lii-500 since it's 12 volts anyways.  I'm not sure how you check for heaters with the fan on the front like this?
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)