Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Sunny island can protocol
#1
Hi
Does anyone know the can protocol for the sunny island (si6048-10us) 
I need it to configure Nuvation bms  for the communication thanks in advance
Reply
#2
When I looked around this was the only page I could find some info on the CAN protocal. But many BMS units can talk to them so I assume SMA will give you the specs.

https://www.elithion.com/lithiumate/php/..._specs.php
Reply
#3
(01-03-2020, 01:13 AM)w0ss Wrote: When I looked around this was the only page I could find some info on the CAN protocal. But many BMS units can talk to them so I assume SMA will give you the specs.

https://www.elithion.com/lithiumate/php/..._specs.php
Thanks for the reply 
I did asked sma but given me the run around I have to send an email to there tech in Germany and they haven’t get back
Reply
#4
I think they all use a standard, but don’t kill me when I’m wrong...
Check this
https://www.batteryspace.com/prod-specs/...bus-v4.pdf
4temps likes this post
30kWh 5x 14s80p with 5x40A China BMS. 14kWH LiFePo4 is in production.
Reply
#5
(01-03-2020, 02:09 AM)Charly144 Wrote: I think they all use a standard, but don’t kill me when I’m wrong...
Check this
https://www.batteryspace.com/prod-specs/...bus-v4.pdf
Thanks
Reply
#6
Hi All, check out this doco from LiTerminal pages 28-29

Has canbus messages specific to SMA..

Hope it helps


.pdf   LiTerminal_Docu_en_sm-SMA CAnbus.pdf (Size: 5.87 MB / Downloads: 50)
hbpowerwall likes this post
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)