Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
18650 for 48v powerwall - charging, discharging and currents?
#1
The project is a 48v 24-ish kWh 14s245p powerwall where I'm using harvested 18650 cells with around 2000 mAh. Based on my house's average energy consumption, I'm looking at roughly 215 mA of continuous current per cell. The 48v inverter I plan to get has shut down voltages at 42v (~3.0v per cell/series) and 59v (~4.2v per cell/series). With this info, when testing the capacity of each 18650 cell, what voltage should I charge each cell to and what cutoff voltage and discharge current should I set for each?
mike likes this post
Reply
#2
When testing capacities, you should always use the full voltage range. This means charging to 4.20V and is discharging to either 2.80V or 3.00V depending on the charger you have. The preferred test current is 1000mA as well even though you calculated the typical use to be 215mA. You want to weed out any faulty or near-failure cells before them make it into your packs Smile
Korishan likes this post
Reply
#3
Discharging at 1000mA does 3 things.
1) Shows pretty much the real capacity under standard conditions for a single cell
2) Shows what the cell "can" do under severe worse case situations
3) Will help weed out the defective/sub-optimal cells

Then in a power application you typically will only pull 250-500mA (usually under the heaviest of loads) and you know the cell can handle it.
This is kinda like a vehicle engine that "can" run at 6000RPMs, but you don't always run it that hard unless you absolutely need to. It'll be short lived if you do run it that high all the time, but will last 1000's of hours if ran 2000RPM or so. Cells are very similar, with the added bonus of not having to change the oil Tongue
Proceed with caution. Knowledge is Power! Literally! Cool 
Knowledge is Power; Absolute Knowledge is Absolutely Shocking!
Certified 18650 Cell Reclamation Technician

Please come join in general chit-chat and randomness at Discord Chat (channels: general, 3d-printing, linux&coding, 18650, humor, ...)
(this chat is not directly affiliated with SecondLifeStorage; VALID email req'd)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)