The last several flashlights I picked up has no spring contact between positive end of cell and circuit board. The cell would not make proper contact.
I was able to carefully bend up the top of cell but I see many examples of magnets for converting flat tops
There are some old thread on why not to use magnets on power wall applications
Is there a recommended size and type to use in single cell applications like flashlights
Tks
I was able to carefully bend up the top of cell but I see many examples of magnets for converting flat tops
There are some old thread on why not to use magnets on power wall applications
Is there a recommended size and type to use in single cell applications like flashlights
Tks