Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
BMS voltages on C- & P-
So I got the new 35A BMS, I plugged in the balancing cables, I have not soldered the thicker negative cables yet but I thought I would check the voltages to see if they resolve the problems above.

So I put one probe on the Battery Main Postive terminal, I then tried each of the Negative solder points on the new BMS,

All three show the full load of the battery of 37v

So my conclusion is that the old one was either faulty or could not cope with the 4 extra amps

Forum Jump:

Users browsing this thread: 1 Guest(s)