Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Is there such a thing as too many breakers?
#5
When doing the cell level fusing do you fuse both sides or is it OK to fuse one side of the cell?

(05-17-2020, 07:49 AM)Redpacket Wrote: You could do a regular breaker for each 7s pack for easy pack isolation & extra safety.
Question about the breakers, can I parallel breakers? Example, using two 50 amp breakers in parallel to get 100 amp breaking capacity. I have been looking at potential power draw, and if I do the math 3000W @ 24V Nominal would require a 125 amp power draw, And if I wanted to do 6000w it would be 250 amp power draw. The highest I have found for a DC breaker ( that is not an ABB or Schnider MCCB's ) is 63 amps.

(05-17-2020, 12:59 PM)Korishan Wrote: Even the older style blade switches would be sufficient for that purpose. And might actually look pretty neat if set up with lots of strings going through them and they are lined up along the wall.
I agree this would look rad, the ones that I am finding on amazon look to cheap and flimsy to look cool though. I will have to look around some more
Reply


Messages In This Thread
RE: Is there such a thing as too many breakers? - by nighthawk28 - 05-23-2020, 10:20 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)