daromer said:The main purpose to separate them is that when you have a charger separated from the load you can disconnect one or the other.
Imagine the battery being full and the BMS is going to disconnect the charger. if you then dont have 2 ports it will also disconnect the load untill the voltage is low enough.. Not optimal scenario right?
Same with the other way around. Lets say your voltage goes to low.. it then disconnects the load but if you have charging on same port you also disconnect charging and you have no way to enable charging again....
ozzy said:Thank you very much, you guys rock!
It helps me a lot
I bought this after a review I saw on the tube :
...
I am not going to pull more than 10a from that thing, there is only one port to charge and discharge so from what I am understanding, there is really no reason to put 2 connectors on the same port. I will not charge and discharge at the same time
Thanks again!