Hi All
I am planning on building an 18650 charger starting with 10 cells, is a TP4056 board the best option considering I want to charge as quickly as possible?
If I do use TP4056, do I need to use a 10 amp power supply to deliver the 1 amp per TP4056?
I have been mucking around with some 1 eBay powerbanks and comparing them to Apple Chargers
I thought that it was the cells that determined at what current they are charged at, but these powerbanks seem to stop charging at about half the mAh I got when I charged them on the iMax (2100 to 2200). They also do not fully discharge, so I can take the cells out of the powebank, stick them in the Imax and drain them much further. My iMax is set to 3v
I got a twin USB charger from eBay rated at 2.1 Amp. I was lucky to get 0.21 amps to 0.49ams, Yet the same charger charges an Iphone6 at 1% per minute, disk doctor suggested iPhone battery was 2562 mAh.
I know the battery condition is a factor but is there anything I need to consider in making this charger?
I was thinking of putting some sort of display?
I was going to get a 10 amp boost supply from eBay, any thoughts?
I am planning on building an 18650 charger starting with 10 cells, is a TP4056 board the best option considering I want to charge as quickly as possible?
If I do use TP4056, do I need to use a 10 amp power supply to deliver the 1 amp per TP4056?
I have been mucking around with some 1 eBay powerbanks and comparing them to Apple Chargers
I thought that it was the cells that determined at what current they are charged at, but these powerbanks seem to stop charging at about half the mAh I got when I charged them on the iMax (2100 to 2200). They also do not fully discharge, so I can take the cells out of the powebank, stick them in the Imax and drain them much further. My iMax is set to 3v
I got a twin USB charger from eBay rated at 2.1 Amp. I was lucky to get 0.21 amps to 0.49ams, Yet the same charger charges an Iphone6 at 1% per minute, disk doctor suggested iPhone battery was 2562 mAh.
I know the battery condition is a factor but is there anything I need to consider in making this charger?
I was thinking of putting some sort of display?
I was going to get a 10 amp boost supply from eBay, any thoughts?