100kwh-hunter
Active member
- Joined
- Mar 2, 2019
- Messages
- 1,374
Hai there,
I am finally ready with my first pack 14s100p
All thecells are 90%soh and2500mah and up.
If i do my match correct i have 56v * 250a = 12kwh?
Next packs will be minimal 2750mah a cell
My pound needs 14.5 kwh a day on 230v.
Before i am going to put it in use i would like to have a minimum of 36-40kwh on storage.
So3 of them(out of ten total 10*14p100s)
I am already making busbars of copper wire 6 * 2,5mm, they can handle up to 75 amp.
Do i really need this thickness? or can i go lower to 4*2,5mm
The first 3 packs (3*14p100s)will have 2 amp fuses, after that 1 amp fuses will be used per cell, i don't think those fuses are to light.
Any advice is very appreciated, thanks in advance
I am finally ready with my first pack 14s100p
All thecells are 90%soh and2500mah and up.
If i do my match correct i have 56v * 250a = 12kwh?
Next packs will be minimal 2750mah a cell
My pound needs 14.5 kwh a day on 230v.
Before i am going to put it in use i would like to have a minimum of 36-40kwh on storage.
So3 of them(out of ten total 10*14p100s)
I am already making busbars of copper wire 6 * 2,5mm, they can handle up to 75 amp.
Do i really need this thickness? or can i go lower to 4*2,5mm
The first 3 packs (3*14p100s)will have 2 amp fuses, after that 1 amp fuses will be used per cell, i don't think those fuses are to light.
Any advice is very appreciated, thanks in advance